Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
300
show gvrp
Purpose Used to display the GVRP status for a port list on the Switch.
Syntax
show gvrp {<portlist>}
Description This command displays the GVRP status for a port list on the Switch.
Parameters
<portlist> − Specifies a range of ports for which the GVRP status is to be displayed.
The beginning and end of the port list range are separated by a dash. Non-contiguous
portlist entries are separated by a comma. (ex: 1-3,7-9)
Restrictions None.
Example usage:
To display GVRP port status:
DGS-3627:admin# show gvrp
Command: show gvrp
Global GVRP : Disabled
Port PVID GVRP Ingress Checking Acceptable Frame Type
------- ---- -------- ---------------- ----------------------
1:1 1 Disabled Enabled All Frames
1:2 1 Disabled Enabled All Frames
1:3 1 Disabled Enabled All Frames
1:4 1 Disabled Enabled All Frames
1:5 1 Disabled Enabled All Frames
1:6 1 Disabled Enabled All Frames
1:7 1 Disabled Enabled All Frames
1:8 1 Disabled Enabled All Frames
1:9 1 Disabled Enabled All Frames
1:10 1 Disabled Enabled All Frames
1:11 1 Disabled Enabled All Frames
1:12 1 Disabled Enabled All Frames
1:13 1 Disabled Enabled All Frames
1:14 1 Disabled Enabled All Frames
1:15 1 Disabled Enabled All Frames
1:16 1 Disabled Enabled All Frames
1:17 1 Disabled Enabled All Frames
1:18 1 Disabled Enabled All Frames
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
enable double_vlan
Purpose Used to enable the Double VLAN feature on the Switch.
Syntax
enable double_vlan
Description
This command, along with the disable double_vlan command, enables and disables the
Double Tag VLAN. When Double VLANs are enabled, the system configurations for VLANs
will return to the default setting, except IP address, log, user accounts and banner setting, in
order to enable the Double VLAN mode. In the Double VLAN mode, normal VLANs and
GVRP functions are disabled. The Double VLAN default setting is disabled.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.