Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
503
DGS-3627:admin# show ospf
Command: show ospf
OSPF Router ID : 10.90.90.90 (Auto selected)
State : Disabled
OSPF Interface Settings
Interface IP Address Area ID State Link Metric
Status
------------ ------------------ --------------- -------- --------- ---------
System 10.90.90.90/8 0.0.0.0 Disabled Link Up 1
Total Entries : 1
OSPF Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost Translate
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None None None
Total Entries : 1
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
create ospf area
Purpose Used to create an OSPF area.
Syntax
create ospf area <area_id> type [normal | [stub | nssa {translate [enable | disable]}]
{stub_summary [enable | disable] | metric <value 0-65535>}]
Description This command is used to create an OSPF area and configure its settings.
Parameters
<area_id> − The OSPF area ID. The user may enter a 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain.
type − The OSPF area mode of operation − the user has three choices to choose from to
define the area created here.
• normal – Choosing this parameter will define the OSPF area created here as a
normal area.
• stub – Choosing this parameter will define the OSPF area created here as a stub
area.
• nssa – Choosing this parameter will define the OSPF area created here as an NSSA
(Not So Stubby Area) area.
• translate [enable | disable] – Enable this parameter to translate Type-7 LSAs
into Type-5 LSAs, so that they can be distributed outside of the NSSA. The
default is Disabled. This field can only be configured if nssa is chosen in the
type field.
stub_summary [enable | disable] − Enables or disables the OSPF area to import summary
LSA advertisements.
metric <value 0-65535> − The OSPF area cost between 0 and 65535. 0 denotes that the value
will be automatically assigned. The default setting is 0. For NSSA areas, the metric field
determines the cost of traffic entering the NSSA area.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage: