Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
599
77
RIPNG COMMANDS
The RIPng commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable ripng
disable ripng
show ripng {ipif <ipif_name 12>}
config ripng {method [no_horizon | split_horizon | poison_reverse] | update <sec 5-65535> |
expire <sec 1-65535> | garbage_collection <sec 1-65535>}(1)
config ripng ipif [<ipif_name 12> | all] {metric <value 1-15> | state [enable | disable] }(1)
debug ripng state [enable | disable]
debug ripng show flag
debug ripng flag [{interface | packet [all | rx | tx] | route}(1) | all] state [enable | disable]
Each command is listed, in detail, in the following sections.
enable ripng
Purpose This command is used to enable RIPng globally for the Switch.
Syntax
enable ripng
Description This command is used to enable RIPng globally for the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable RIPng globally:
DGS-3627:admin# enable ripng
Command: enable ripng
Success.
DGS-3627:admin#
disable ripng
Purpose This command is used to disable RIPng globally for the Switch.
Syntax
disable ripng
Description This command is used to disable RIPng globally on the Switch. The default setting is
disabled.
Parameters None.