Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
705
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the Switch.
Syntax
show traffic_segmentation {<portlist>}
Description
The show traffic_segmentation command is used to display the current traffic
segmentation configuration on the Switch.
Parameters
<portlist> − Specifies a port or range of ports for which the current traffic
segmentation configuration on the Switch will be displayed. The beginning and
end of the port list range are separated by a dash. Non-contiguous portlist entries
are separated by a comma. (ex: 1-3,7-9)
Restrictions The port lists for segmentation and the forward list must be on the same Switch.
Example usage:
To display the current traffic segmentation configuration on the Switch.
DGS-3627:admin# show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- -------------------------------------------------
1:1 1:1-1:25
1:2 1:1-1:25
1:3 1:1-1:25
1:4 1:1-1:25
1:5 1:1-1:25
1:6 1:1-1:25
1:7 1:1-1:25
1:8 1:1-1:25
1:9 1:1-1:25
1:10 1:1-1:25
1:11 1:1-1:25
1:12 1:1-1:25
1:13 1:1-1:25
1:14 1:1-1:25
1:15 1:1-1:25
1:16 1:1-1:25
1:17 1:1-1:25
1:18 1:1-1:25
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All