Fujitsu Fujitsu SPARC64 V Computer Accessories User Manual


 
F.APPENDIX
213
R
UPA Programmer s Model
This chapter describes the programmers model of the UPA interface of the
SPARC64 V. The registers for the UPA interface and the access method for those
registers are described. The appendix contains the following sections:
Mapping of the CPUs UPA Port Slave Area on page 213
UPA PortID Register on page 214
UPA Config Register on page 215
R.1 Mapping of the CPUs UPA Port Slave
Area
TABLE R-1
shows the mapping of the CPUs UPA port slave area.
TABLE R-1
CPUs UPA Port Slave Area Mapping
Relative Address
(Hex) Length Possible Access Contents
0 0000 0000 8 Slave read from other
UPA port
UPA PortID Register; defined in
Section R.2.
000000008
~ 1 FFFF FFFF
-- None Nothing. Write is ignored and
undefined value is read.