Filter
Top Products
Table 13-3
Whether PHP can be used (continued)
Root Complex PCIe slot Can PHP be
used?
Remarks Reference
Control domain I/O domain No See *6 in the example of
executing the ldm list-io -l
command and *6 in Figure
13-2.
"Table 13-4 Operations
when PHP cannot be used
or you do not use PHP"
Root domain Root domain Yes See *7 in the example of
executing the ldm list-io -l
command and *7 in Figure
13-2.
"13.4.1 Active/Hot
maintenance (with PHP)"
Root domain I/O domain No See *8 in the example of
executing the ldm list-io -l
command and *8 in Figure
13-2.
"Table 13-4 Operations
when PHP cannot be used
or you do not use PHP"
Table 13-4
Operations when PHP cannot be used or you do not use PHP
System configuration Operation Reference
Building block Use building block configuration DR to
release the target chassis from the physical
partition (*1).
"13.4.2 Active/Hot maintenance
(with DR)"
Single-chassis co nfigu r a tio n
Stop the system, and then perform
maintenance.
"13.4.4 System-stopped maintenance"
*1: If you do not use DR, the same procedure as for a single-chassis configuration should be performed.
13.4 Enabling the Removal of a PCI
Express Card
This section describes the preparations that must be completed prior to the removal
of a PCIe card. The preparation procedure differs depending on the maintenance
type as follows:
■
Active/Hot maintenance (with PHP)
■
Active/Hot maintenance (with DR)
■
Inactive/Hot maintenance
■
System-stopped maintenance
13.4.1 Active/Hot maintenance (with PHP)
1.
Open the r ack do or.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
December 2013246