Filter
Top Products
XSCF>
showstatus
XSCF>
showhardconf
SPARC M10-4S;
+ Serial:2081235006; Operator_Panel_Switch:Locked;
+ System_Power:Off; System_Phase:Cabinet Power Off;
Partition#0 PPAR_Status:Powered Off;
BB#00 Status:Normal; Role:Master; Ver:2047h; Serial:2081235006;
+ FRU-Part-Number:CA07361-D202 A1 ;
+ Power_Supply_System: ;
+ Memory_Size:160 GB;
------------------------
Ommitted
------------------------
BB#01 Status:Normal; Role:Standby; Ver:2047h; Serial:2081228004;
+ FRU-Part-Number:CA07361-D202 A0 ;
+ Power_Supply_System: ;
+ Memory_Size:128 GB;
------------------------
Ommitted
-----------------------
XSCF>
switchscf -t Standby
6.3 Powering On the Physical Partition
Requiring Maintenance
This section describes the procedure for powering on a physical partition requiring
maintenance.
1.
Switch the mod e switches of the master chas sis and thos e chassis whose
XSCFs are in the standby state to Locked mode.
-
For a building block configuration (w ithout crossbar bo x)
Switch the mode switches of BB-ID#00 and #01 to Locked mode.
-
For a building block configuration (w ith crossbar bo x)
Switch the mode switches of BB-ID#80 and #81 to Locked mode.
2.
LogintotheXSCFshell.
3.
Execute the sho w status command to confirm t h at there is no problem with
the FRU after the completion of maintenance.
If there is no problem, nothing is displayed.
4.
Execute the sho w hard conf command t o check the hardware confi guration
and t h e status of each component.
5.
If the state of the m aster chassis r equiring maintenance h as been switched to
the standby state before maintenance, e x ecute the s w itchscf command to
switch the cha ssis to the master XS CF.
6.
Execute the poweron command t o power on the stopped p h ysical partition.
Chapter 6 Understanding the Preparations for Restoring the System 73