Filter
Top Products
XG Series User's Guide Chapter 5 Command Reference
Port Information Settings
114
5.1.1.24 linkaggregation icmpwatch address
Function Set the destination address for "ether" L3 monitoring of link aggregation.
Available Model XG0224 / XG0448 / XG2600
Syntax linkaggregation <group> icmpwatch address <dst_addr>
Options
<group>
•
Link aggregation group number
Set a link aggregation group number with a decimal number.
<dst_addr>
•
Destination IP address to be monitored
Specify the destination IP address to be monitored.
The allowable range is as follows:
1.0.0.1 to 126.255.255.254
128.0.0.1 to 191.255.255.254
192.0.0.1 to 223.255.255.254
Use Mode Configuration mode (admin class)
Explanation Set the operation information for destination monitoring.
This command sends an ICMP ECHO packet from the specified link aggregation group to
the destination IP address, specified by <dst_addr>, and checks the presence of the
destination by receiving a response.
Caution Do not set the IP address of the local device in <dst_addr>. Also, make sure that the
specified IP address is included in the same subnet.
If any of the above three addresses is specified, the Ethernet L3 monitoring function will
not operate normally.
Default It is assumed that the Ethernet L3 monitoring function is not used for the link aggregation.
Range Model
1 to 13 XG0224
1 to 26 XG0448
1 to 10 XG2600