Filter
Top Products
XG Series User's Guide Chapter 5 Command Reference
LAN Information Settings
205
1) "vlan ip6qos aclmap" command
A smaller VLAN ID has a higher priority among VLANs.
2) "lan ip6 dscp" command
A smaller lan definition number has a higher priority among lans.
If up to 128 of "vlan ip6qos aclmap" commands have been defined, the subsequent
"lan ip6 dscp"command will be no longer applied.
• Upper limit based on rule
128 rules for the entire device.
For the "vlan ip6qos aclmap" and "lan ip6 dscp" commands, the number of rules to be
used varies depending on the contents of the specified acl as shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
You can expand the upper limit to use "resource filter distribution" command and change
resource distribution.
Note 4.
Up to 700 commands can be set for the entire device, including the definitions which refer
to ACL such as "ether macfilter", "ether qos aclmap", "vlan macfilter", "vlan ip6filter",
"vlan qos aclmap", "vlan ip6qos aclmap", "lan ip filter", "lan ip dscp", "lan ip6 filter", "lan
ip6 dscp" and "serverinfo filter" commands.
Default It is assumed that DSCP value rewriting is not performed.