Filter
Top Products
XG Series User's Guide Chapter 5 Command Reference
Device Information Settings
309
5.15.8.16 serverinfo telnet ip6
Function Set the IPv6 telnet server function
Available Model XG0224 / XG0448 / XG2600
Syntax serverinfo telnet ip6 <mode>
Options
<mode>
•
on
Enable telnet server function
• off
Disable telnet server function
Use Mode Configuration mode (admin class)
Explanation Set the IPv6 telnet server function
Default It is assumed that the IPv6 TELNET server function is enabled.
5.15.8.17 serverinfo telnet filter
Function Set the application filter for the TELNET server function.
Available Model XG0224 / XG0448 / XG2600
Syntax serverinfo telnet filter <count> <action> acl <acl_count>
Options
<count>
• Filtering definition number
Specify a definition number, which indicates a filtering priority, with a decimal value
from 0 to 29.
A smaller value has a higher priority.
<action>
Specify an operation when filtering conditions are satisfied.
• accept
Transmit the relevant packet.
• reject
Block the relevant packet.
<acl_count>
•
ACL definition number
Specify the required ACL definition number with a decimal value.
If the ACL specified in <acl_count> is not specified, the filtering definition will be
disabled and ignored.
The following ACL definition is available for application filtering.
• ip
Set only the source IP address and the number of mask bits.
If the ip value is not set, the filtering definition will be disabled and ignored.
Use Mode Configuration mode (admin class)
Explanation Set the application filter for the TELNET server function.
Default It is assumed that the application filter is not set for the TELNET server function.
serverinfo telnet ip6 on