Filter
Top Products
XG Series User's Guide Chapter 5 Command Reference
VLAN Information Settings
170
5.3.3.3 vlan ip6filter
Function Set VLAN IPv6 filter
Available Model XG0224 / XG0448
Syntax vlan <vid> ip6filter <count> <action> <acl>
Options
<vid>
•
VLAN ID
Specify the VLAN ID with a decimal value from 1 to 4094.
<count>
•
Priority
Set the filtering priority with a decimal value
A smaller value has a higher priority.
<action>
•
pass
Pass the packets which match "acl ip6", "acl icmp", "acl tcp" and "acl udp"
• reject
Discard the packets which match "acl ip6", "acl icmp", "acl tcp" and "acl udp"
<acl>
•
ACL definition number
Specify the ACL definition number which is used for the filter
Use Mode Configuration mode (admin class)
Explanation Set IPv6 filtering per VLAN
Action specified in <action> works packets which match access control list which is
defined in "acl ip6", "acl icmp", "acl tcp" and "acl udp"
Caution
Note 1.
If none of "acl ip6" definition exist on the access control list which has been specified by
<acl> or if the access control list specified by <acl> does not exist, the packets are not
filtered.
Note 2.
The packet filtering default value is "pass".
No packets are filtered if only "pass" is set in <action>.
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the "vlan ip6filter" and
"lan ip6 filter" commands.
The priority for each command is as follows.
Range Model
0 to 511 XG0224 / XG0448