Filter
Top Products
XG Series User's Guide Chapter 5 Command Reference
LAN Information Settings
197
5.5.1.8 lan ip arp static
Function Sets static ARP.
Available Model XG0224 / XG0448
Syntax lan [<number>] ip arp static <count> <dst> <mac>
Options
<number>
•
Defined LAN number
The sequential number of a LAN definition expressed in base 10.
Default is 0.
<count>
•
Static ARP table entry number
The static ARP table entry number, expressed as a base 10 number from 0-199.
If an entry already exists in the table at the entry number specified, the command will
modify the existing entry.
<dst>
•
Destination IP address
Specifies the destination IP address to be registered in the static ARP table.
Below are the ranges of IP addresses that may be specified.
<mac>
•
MAC address
Specifies the MAC address to use when sending packets to the destination IP address.
Specify in the format xx:xx:xx:xx:xx:xx (where xx is a two-digit, base 16 value).
Use Mode Configuration mode (admin class)
Explanation Sets static ARP entries in the ARP table.
Caution Multiple ARP entries may not be made for the same destination IP address.
The static ARP function will not operate for interfaces in which the IP address is not set.
MAC addresses cannot be set to broadcast or multicast.
Default If unset, the static ARP function will not be used.