Filter
Top Products
XG Series User's Guide Chapter 3 Installation
Workflow for Initial Setup of the Device
58
3.1.3 SNMP Configuration (Optional)
To operate in conjunction with an SNMP manager, the SNMP agent must be configured.
To configure the SNMP agent, carry out the following procedures in "admin" Operation mode.
Command Task
XG2600# configure Switch to Configuration mode.
XG2600(config)# snmp service on Enable SNMP function.
XG2600(config)# snmp agent contact SYSTEM-
CONTAC
Set the swith's contact (SYSTEM-CONTACT).
XG2600(config)# snmp agent location SYSTEM-
LOCATION
Set the swith's location (SYSTEM-LOCATION).
XG2600(config)# snmp agent address A.B.C.D Set the SNMP agent address. This setting is also used for the local
address at trap transmission.
Make sure to set it when using the SNMP agent function
XG2600(config)# snmp manager 0 A.B.C.D
COMMUNIT-YNAME v2c disable
Set the IP address (host name) of the SNMP manager, the commu-
nity name, sending SNMPv2 traps, and disabling writing. if the SNMP
trap notification is enabled.
XG2600(config)# commit Apply the configuration.
XG2600(config)# save Save the configuration.
XG2600(config)# exit Switch to Operation mode.
XG2600# configure Switch to Configuration mode.
XG2600(config)# snmp service on Enable SNMP function.