Filter
Top Products
XG Series User's Guide Chapter 5 Command Reference
Port Information Settings
141
The following commands spend 1 action for each.
If same <tos_value> is used, the commands use 1 action for them.
If same <dscp_value> is used, the commands use 1 action for them.
If same <queue_value> is used, the commands use 1 action for them.
- ether <number> qos aclmap <count> tos <tos_value> <acl>
- ether <number >qos aclmap <count> dscp <dscp_value> <acl>
- ether <number> qos aclmap <count> queue <queue_value> <acl>
- vlan <vid> qos aclmap <count> tos <tos_value> <acl>
- vlan <vid> qos aclmap <count> dscp <dscp_value> <acl>
- vlan <vid> qos aclmap <count> queue <queue_value> <acl>
- lan <number> ip dscp <count> acl <acl_count> <dscp_value>
The following commands spend 1 action for each.
If same <vid> is used, the commands use 1 action for them.
- vlan <vid> protocol <count> ether
- vlan <vid> protocol <count> llc
Note 5.
When the port type of the Ethernet port is a link aggregation, the same setting is needed
in all the member ports where the link aggregation is composed.
[XG0224/XG0448]
Note 2.
If a queue is selected by <action> and if this queue has not been associated with the cos
value by the "qos cosmap" command, the QoS processing is not executed.
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the "ether qos aclmap",
"vlan qos aclmap" and "lan ip dscp" commands.
1) "ether qos aclmap" command
A smaller Ethernet port value has a higher priority among Ethernet ports.
2) "vlan qos aclmap" command
A smaller VLAN ID has a higher priority among VLANs.
3) "lan ip dscp" command
A smaller lan definition number has a higher priority among lans.
If up to 128 of "ether qos aclmap" commands have been defined for port ether1, the
subsequent "vlan qos aclmap" and "lan ip dscp" command will be no longer applied.
• Upper limit based on rule
128 rules for the entire device.
For the "ether qos aclmap", "vlan qos aclmap" and "lan ip dscp" commands, the
number of rules to be used varies depending on the contents of the specified acl as
shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP