Filter
Top Products
4 - 19
Operating Procedure
The following procedures are the same as the
Operating Procedure
in section
4.4.
(1) Creating a new project
(2) Creating a program
(3) Writing the project to the programmable controller
(4) Monitoring the ladder
Operation Practice
• Turning on X2 turns on Y70, and turning on X0 turns off Y70. (Even when X2 stays
on, turning on X0 turns off Y70.)
• Turning on X3 turns on Y71, and turning on X1 turns off Y71.
Related Exercise
–––– Exercise 3
REMARK
Input pulse processing is not required for the QCPU as it uses a derivative
contact (
/ ).
[For A/AnSCPU]
X0
M0
PLS M0
SET M5
[For QCPU]
X0
SET M5
Supported instructions are; LDP, LDF, ANDP, ANDF, ORP, and ORF.