Filter
Top Products
2 - 45
2.10 Editing Ladder Program
2.10.1 Modifying a part of the ladder program
This section explains how to modify a part of the
ladder program shown on the left.
(OUT Y71 → OUT Y72)
1) Confirm that "Ovrwrte" is shown at the
lower-right portion of the screen.
If "Insert" is shown on the screen, click the
Ins
key
to change the display to "Ovrwrte".
If "Insert" is shown on the screen, contacts or coils are
added to the diagram.
Added!
X5 X2
<When correcting X2 to X5>
Added!
RST M3
SET
M3
<When correcting SET to RST>
X2
X0
Y70
Y70
X3
Y71
Y72
A ladder program to be created
1) Check!
2) Double-click!
(To the next page)
2) Double-click the point to be corrected.