Filter
Top Products
218 Chapter 25 Feature configuration: Making calls
N0060600N0060600
Preventing voice announcements at a telephone
Prevent your telephone from receiving voice announcements by using:
FEATURE 88 or FEATURE 85 (Do not Disturb)
Create a conference call
You can establish calls to two people at the same time, and allow each caller to hear the other two
callers. You must have at least two intercom paths assigned to your telephone to initiate a
conference call.
The person who establishes the conference call has several options available to provide control
within a conference call.
• remove callers temporarily (put on Hold), or permanently
• split the conference into two separate calls
• leave the conference, and allow the other two callers to remain connected
Setting a conference tone
If your profile allows it, you can configure the system to sound a tone when a conference call is
established.
Configuration > Telephony > Global Settings > Feature Settings
To set up a 3-party conference call
1 Place or answer the first call.
2 Put the first call on hold.
3 Place or answer the second call.
4 After the second call is connected, press FEATURE 3
.
5 Press the line or intercom button of the first held call (not required on the 7100 digital phones).
6 Press RLS to end the conference call.
To set up an Ad-hoc multiparty conference call
1 Complete the procedure for the 3-party conference call.
2 The conference master enters FEATURE 807 or presses the NEWCALL softkey.
The conference is placed on hold.
3 Dial the fourth party number.
The fourth party answers the call.