Filter
Top Products
Chapter 27 Display prompts and messages 243
BCM 4.0 Device Configuration Guide
Release calls
You tried to use a feature while you were on a call or had calls on hold. Release the
call, or calls, before using the feature.
Silent monitor: You entered the silent monitor feature code on a telephone that
already has an active call. To continue, you must place that call on hold, or release it.
Restricted call
The destination you selected for line redirection is restricted.
System programming has a restriction configured for the call you are trying to make,
such as time-of-day restrictions for some calls.
Restricted call
CANCL RETRY
Transfer: You cannot transfer the call because of telephone or line restrictions.
Ring Again?
YES NO EXIT
Press YES to use Ring Again. Press NO to send a message.
Select a line
Either you have no prime line, or the prime line is in use, or the line programmed for
an auto dial number, speed dial number, or Hotline is in use. Select a line and dial
again.
Speed dial: There is no line related with the speed dial number you are trying to use.
Select a free external line or line pool and enter the speed dial feature code again.
Select line out
QUIT
Line redirection: Select the line used to redirect calls out of the system.
Select line(s)
QUIT ALL
Line redirection: Press the lines to redirect. To release a line selection, press the line
to redirect again. Press
ALL to redirect all your lines.
Cancel redirection: Press the lines that no longer need redirection. The lines light up
when pressed. After you cancel redirection for a line you cannot restore it by
pressing the line again. Press
ALL to cancel redirection for all your lines. When
finished, press
HOLD or OK.
Select line(s)
ALL OK
Line redirection: Continue to press the lines to redirect. Press HOLD or OK when
finished.
Cancel redirection: Continue to press the lines that no longer need redirection. Press
HOLD or OK when finished.
Send message?
YES NO
Press YES to send a message. See Messages.
Set locked
You cannot use the feature you selected because your telephone is locked.
SetNam2 SetNam3
NEWCALL TRANSFR
The active call display for a three-party conference master.
Start of list
NEXT
Message: You are at the beginning of your list of messages. Press NEXT to move
through your messages.
Still in trnsfer
CANCL RETRY
Transfer: Complete the transfer in progress before you access a new feature, answer
another call, or select an outgoing line.
Supervisor
Observe
Silent monitor: The DN you entered belongs to another Supervisor. You cannot
monitor SM supervisor telephones. Press
Observe to enter another hunt group
telephone.
Display prompt Description of error or action