Filter
Top Products
Chapter 6 DN records parameters 47
BCM 4.0 Device Configuration Guide
Appearance Type Ring only, Appr&Ring,
Appr only
Select how a call on this line appears on the telephone.
If you choose Appr&Ring or Appr only, you can have as many
simultaneous DID calls as there are target line button appearances.
If you choose Ring only, you can have as many simultaneous DID
calls as you have intercom buttons.
Note: The BCM does not support a mixture of Appr only and Ring
only appearances for the same line.
7000 or 7100 digital phones default to Ring only.
(Model 7000 phones are supported in Europe only)
Appearances
(for target lines, only)
<1-255> Select the number of appearances of a target line.
Note: The number of appearances that can be assigned to a
telephone depends on how many buttons with indicators are
available. Target line appearances cannot overwrite other line
appearances, Answer DNs, Intercom buttons, or assigned
Handsfree button.
Caller ID set <check box> This prompt only appears for target lines, and for any analog lines
that provide CLID through an GATM (not all markets).
When enabled, the telephone displays call information when it is
available for a call before answer.
When disabled, no call information is displayed for this line. Choose
this setting if the telephone does not have a display, or if you do not
want call information displayed to the user. Disabling this function
can reduce system resource requirements.
Note: Only 30 telephones can have this field enabled for any given
line.
Vmsg Set <check box> Select whether an indicator shows on the telephone for a voice
message waiting on an external voice message system.
The line must appear on the receiving telephone.
Note: The Message Waiting Indicator (MWI) is currently supported
exclusively by Meridian Mail and CallPilot and SL-100, and
DMS-100.
MCDN note: If your system is part of an MCDN network connected
to a Meridian 1 system, and you are using the voice mail system off
the Meridian 1, you must enable this field.
Analog lines connected to legacy analog ASM station modules, and
analog telephones attached to an ATA device, do not provide visible
message waiting indication. Analog telephones connected to a
GASM8 support message indicators, if the telephone is set up to
receive them.
Note: Contact your voice message service provider to find out if your voice message service
works with BCM, or if you have any problems with your service.
Priv. Received #
(Target lines only)
These fields reflect the settings defined under target lines.
These are the digit strings that the system uses to identify a call for this telephone.
Refer to “Trunk/Line Data, main panel” in the BCM 4.0 Networking Configuration Guide
(N0060606).
Pub. Received #
(Target lines only)
Actions
Table 10 Telephone line assignment fields (Sheet 2 of 3)
Attribute Values Description