Filter
Top Products
Chapter 30 Configuring the music source 283
BCM 4.0 Device Configuration Guide
Figure 66 Music panel
Table 81 Music parameters (Sheet 1 of 2)
Setting Definition
Music Source Select Audio Jack if you are using an external music source that is connected to the MSC
card on the BCM.
Select Music Manager if you are using the IP Music feature to connect to the music source
available on the BCM. If you select Music Manager, you must then configure the BcmAmp
application before you can use it. For information about how to configure BcmAmp, refer to
“Configuring Music Manager” on page 285.
Select Streaming Server if you are using the IP Music feature to connect to a music
source on the data network. If you select Streaming Server, you must configure the
Network Device before you can use it. For information about how to configure the Network
Device, refer to “Configuring a Network Device to be the IP Music Source” on page 290.
Note: A third party application that supports audio streaming is required. It must adhere to
the RTP protocol and support one of the following codecs: G.711, G.729, or G.723.
Audio Jack
Server Field not required.
Server RTP port Field not required.
Stream Type Field not required.
Frames per packet Field not required.
Music Manager control
Launch Music Manager Launch the Music Manager Administration web page
Server Field not required.
Server RTP port Field not required.
Stream Type Field not required.