Filter
Top Products
Chapter 6 DN records parameters 55
BCM 4.0 Device Configuration Guide
Capabilities and Preferences - SWCA Call Group tab
Although System-wide Call Appearance (SWCA) assignments are meant to be assigned to buttons
with indicators, you can assign SWCA assignments to a telephone without assigning them to
buttons using the fields on this panel. This is useful if you want to use the full range of SWCA
assignments.
Use the SWCA Call Group tabbed panel to enable or disable Call 1 to Call 16 assignments for
each sets. The administrator can configure the 16 SWCA feature codes on all the sets through
administration.
Users can park or retrieve calls on any SWCA assignment, even if the call is not directly assigned
to their telephone. However, the SWCA support codes (FEATURE *520, FEATURE *537 and
FEATURE *538) only search for SWCA assignments that are assigned to the telephone where the
feature is invoked. These codes are required for users who do not have buttons with indicators.
Allow redirect <check box> Define whether this telephone allows assigned lines to be redirected.
This must be selected to allow call forwarding outside the network (external
call forward), including calls to a centralized voice mail system over a
private network.
Default: Cleared
Redirect ring <check box> Define whether the telephone rings briefly when a call on one of its lines is
redirected by the Line Redirection feature (FEATURE 84).
Also refer to “Trunk/Line Data, main panel” in the BCM 4.0 Networking
Configuration Guide (N0060606).
Default: Selected
Receive short tones <check box> Analog equipment, which is connected to the system with an internal or
external analog terminal adapter (ATA2), responds only to tone dialing
signals.
Select this setting only if you have analog equipment connected to a station
port.
Default: Cleared
Silent monitor
supervisor
<check box> On two-line display telephones only, you can choose whether the telephone
can be used to allow the Silent Monitor feature. Select the check box to
allow this feature on this telephone.“Silent Monitor” on page 81“Monitoring
Hunt Groups” on page 107.
Default: Cleared
Table 14 Capabilities and Preferences - Capabilities tab (Sheet 3 of 3)
Attribute Values Description