Filter
Top Products
Chapter 6 DN records parameters 51
BCM 4.0 Device Configuration Guide
• “Capabilities and Preferences - Button Programming tab” on page 58
• “Capabilities and Preferences - ATA Settings tab” on page 62
• “Capabilities and Preferences - IP Terminal Details tab” on page 64
Capabilities and Preferences - Properties tab
The Properties settings control how calls are displayed, as well as assignment of control sets to
individual telephones.
Figure 12 Capabilities and Preferences - Properties tab
Table 13 describes the fields shown on the main Capabilities and Preferences tabbed panel.
Table 13 Capabilities and Preferences tabbed panel (Sheet 1 of 2)
Attribute Values Description
Prime Line None, Pool (A to O),
I/C (intercom),
Line: <line number>
Choose the first line that the telephone selects when a call is made. PRI
Bloc pools are not valid selections for a Prime line.
When you assign a line pool as a prime line, the system searches
automatically for an idle line in the pool.
Intercom Keys 0 to 8 Assign the number of intercom buttons to a telephone.
Intercom buttons provide a telephone with access to internal and external
lines, and to line pools.
Control Set DN: <any telephone
DN>
None
DN:221<start DN>*
The Control telephone attribute allows you to define a DN that acts as a
control telephone.
A control telephone is used to enable/disable Scheduled Services, such
as Restriction Services, for the telephones to which it is assigned. For
more information about services, see “System schedule settings and
services scheduling” on page 29.
You can assign several control sets for your system, but you can only
assign one control telephone per DN.
* If you change the Start DN, this number reflects that change.