Filter
Top Products
99
BCM 4.0 Device Configuration Guide
Chapter 14
Configuring Hunt Groups
The Hunt Groups panel allows you to set up call groups that are assigned a common hunt group
DN for incoming calls. The calls then are distributed to the member telephones.
The following paths indicate where to configure hunt groups in Element Manager and through
Telset Administration:
• Element Manager: Configuration > Telephony > Hunt Groups
• Telset interface: **CONFIG > System prgrming > Hunt Groups
Click one of the following links to connect with the type of information you want to view:
Panel tabs Tasks
“Hunt Groups system setup” on page 100 “Configuring the Hunt Group general settings” on page 103
“Hunt Group members and lines” on page 103 “Monitoring Hunt Groups” on page 107
Also refer to: “Programming name display (outgoing)” in the BCM 4.0
Networking Configuration Guide (N0060606)
“Silent Monitor” on page 81
Click the navigation tree heading to access general information about user management.