Filter
Top Products
26 Chapter 3 System Software
N0060600N0060600
Click one of the following links to connect with the type of information you want to view:
Figure 4 Date and time panel
Table 2 describes each field on the Date and Time panel.
Panel Task
“Setting clock control to local system” on page 28
Click the navigation tree heading to access general information about Date and Time management.
Table 2 Date and Time panel fields (Sheet 1 of 2)
Attribute Value Description
Date and Time Source NTP
Trunk
Manual
Set to NTP (Network Time Protocol) if the system uses a
network server to determine the correct time and date.
Set to Trunk to use time and date settings from a CO through
an analog or ISDN line.
Set to Manual if you want to be able to manually configure the
time and date for your system.
Network Time Protocol Settings
(Settings are active only if Clock Control Type is set to Network Time Protocol.)
NTP server address <IP address> The IP address of the server that controls the network time and
date.