Filter
Top Products
Chapter 5 System features and feature codes 37
BCM 4.0 Device Configuration Guide
• Some features also require that the service be available on the line from your telephone service
provider. The types of lines provided are also determined by the region chosen for your
system. MCID (malicious call identification) is an example of this type of feature.
Table 7 Button Programming Feature settings (Sheet 1 of 4)
Set command
(FEATURE
<code>)
Feature Description
None Indicates a button that is configured for button programming, but nothing
has been entered.
0 Speed dial Activates the speed dial feature. The telephone prompts the user for a
speed dial code.
1 Send message Allows the user to send a message to another DN on the system.
#1 Cancel send message Allows the user to cancel a message that was sent to another set within
the network.
2 Ring again Turns on the Ring again feature.
3 Conference/Transfer Initiates a conference between user and two parties.
4 Call forward Allows the user to enter a number to forward all calls.
Note: Allow redirect must be selected to forward calls outside of the
system.
5 Last number redial Causes set to redial the last number that was dialed.
*5 Language choice Allows the user to select the language in which prompts are displayed.
60 Page - general Initiates a page.
61 Page - Internal Allows the user to page internal to a specific zone, which is identified
within the Button programming. (For example F611 internal zone 1, F610
page internal all zones.)
62 Page - External Allows the user to page through the speaker on a specific telephone.
63 Page - speaker and zone Allows the user to page through both the internal sets, and externally
connected paging equipment to a specific zone, which is identified within
Button programming.
64 Line pool Allows the user to access a line pool. The pool this button accesses is
specified during Button Programming for this feature.
65 Reply message Allows the user to access messages, and send a reply to the message
sender.
#65 Cancel message waiting Allows the user to cancel the message waiting indicator.
66 Voice call Allows the user to make an announcement, or begin a call through the
speaker of another telephone.
67 Saved number redial Allows the user to redial a number that was saved while on a call.
68 Restriction override Allows the user to override any restrictions on the set or line with a CoS
password.
69 Priority call Allows the user to priority call an internal DN that is currently busy.
*7 Contrast Allows the user to adjust the contrast of the display screen.
70 Transfer Allows the user to transfer an existing call to another telephone or
external number.