Filter
Top Products
Chapter 6 DN records parameters 45
BCM 4.0 Device Configuration Guide
Figure 8 Properties tab
Table 9 describes these fields.
Table 9 Line Access tab fields (Sheet 1 of 2)
Attribute Value Description
Pub. OLI <up to 12 digits> This setting defaults to the DN of the device. The Public Network
Code concatenates to the beginning of this number to create the
entire public network number. The length of this number is
dependent on the country requirements.
This line identification number (OLI) appears on the telephone called
from this telephone over the public network. Also refer to “Public
network settings” in the BCM 4.0 Networking Configuration Guide
(N0060606).
North America: If the OLI contains the public network code, the
information in the Public Network code field is ignored. Therefore, it
is recommended that OLIs be programmed to the public received
number length, only. This allows a global change if the Public
Network Code is changed.
Also refer to “Configuring CLID on your system” in the BCM 4.0
Networking Configuration Guide (N0060606).
Priv. OLI <numeric> Define the originating line identification number (OLI) that appears
on the telephone being called from this telephone over a private
network.
Note: On systems running DID, this field is populated automatically
with the DN.
If the DN length or the Received # length are changed to be different
from each other, this field is cleared.
Also refer to “Configuring CLID on your system” in the BCM 4.0
Networking Configuration Guide (N0060606).
*If your system allows outgoing name and number blocking, the telephone must have a valid OLI.