Filter
Top Products
Chapter 27 Display prompts and messages 239
BCM 4.0 Device Configuration Guide
Line denied
You selected a line that is private to another telephone.
Trunk Answer: You have tried to pick up a call on a private line.
Line in use
The line is in use. Make the call using normal methods, or wait until a line is free.
Line Redirection
QUIT ADD REMOVE
Line redirection: Press * or ADD to begin redirection. Press # or REMOVE to cancel a
previous redirection.
Messages & Calls
MSG CALLS
Message: You have one or more messages, and one or more new Call Logs. Press
FEATURE 806 to change the first line of the display to the current time and date.
Make calls first
The feature you tried to use requires you to be on an active call at your telephone.
This prompt also appears when information about a call is cleared by a system reset.
Message denied
Message: You tried to send a message to an invalid internal number, or to a
telephone that is out of service.
Message list
SHOW ADD EXIT
Message: SHOW appears when you have remaining messages. Press SHOW to
review messages you have sent. Press
ADD to send a new message.
Message to:
Message: Enter the internal number of the telephone to which you want to send a
message.
Microphone muted
Voice call: Your handsfree microphone is on the mute setting. Press the button
labeled Handsfree/Mute, or pick up your handset to respond to the voice call.
Move line from:
QUIT
Move button: Press the button of the line you want to move. Press FEATURE or
QUIT when you have finished moving lines.
Move line to:
QUIT
Move button: Press the button of the line to which you want to move the current line.
Neither of the buttons is erased. The lines, or the line and feature, switch places.
Need Handsfree
Silent monitor: You entered the silent monitor feature code without lifting the
handset, and the telephone does not support Handsfree operation.
No avail SWCA
SWCA: The FEATURE *520 request was unsuccessful, either because the
telephone has no associated SWCA keys, or all the SWCA keys for that telephone
are associated with other calls.
Note: If the call is an internal call and the destination set has a SWCA associated
with the call, and if the originating set requests that the call be associated with a
different SWCA, then the destination telephone transfers the call to the new SWCA
position. If the destination telephone does not have a button programmed for the new
SWCA position, the call disappears from all SWCA button appearances, and can
only be retrieved by entering the corresponding SWCA code.
No button free
You tried to make, receive, or pick up a call when no line button was available. Some
features require you to have a button free. Releasing calls can free up line buttons.
Message: You have no line button free with which to reply to a message.
No call to park
Call park: You have tried to use Call Park with no active call on your telephone. If the
call you want to park is on hold, reconnect to the call before you park it.
No call on: 101
Call park: There was no call on the retrieval code (101-125) that you entered.
Display prompt Description of error or action