Filter
Top Products
62 Chapter 6 DN records parameters
N0060600N0060600
Capabilities and Preferences - ATA Settings tab
Analog telephones have some settings that are specific to the analog connection. An analog
telephone can be connected to the system directly through an analog station port, either on the
Main Unit (in countries that support Main Unit Analog Stations) or through Analog Station Media
Bay Modules. These settings apply only when the DN record Model field is set to analog.
Analog telephones can also be connected by using an Analog Terminal Adapter (ATA2). The
digital station port can be on the main unit, or on a Digital Station Media Bay Module.
Facility Use prime line
Use routing table
Select the route you want the dialed number to take out of your system.
Note: Any line numbers or line pool codes that you specify must be
assigned to the telephone where the code is entered.
If you choose prime line, a prime line must be assigned to the telephone
where the code is entered.
Refer to “Line Access - Line Assignment tab” on page 46.
Actions
Add 1. On the Capabilities and Preferences tab, choose the DN record where you want to add User
Speed dials.
2. Under the User Speed Dial Numbers table, click Add.
3. Enter the appropriate speed dial number.
4. Click OK.
5. On the User Speed Dial, click the External Number field beside the number you entered.
6. Enter an external number to dial.
7. Click the Facility field beside the number you entered.
8. Enter how the number must be routed out of the system.
Delete 1. On the Capabilities and Preferences tab, choose the DN record where you want to delete User
Speed dial entries.
2. On the User Speed Dial Numbers table, click the user speed dial code or codes that you want to
delete.
3. Click Delete.
4. Click Yes.
Table 17 Capabilities and Preferences - User Speed Dial panel fields (Sheet 2 of 2)
Setting Values Description