Filter
Top Products
32 Chapter 4 System schedule settings and services scheduling
N0060600N0060600
Schedule <read-only> These are the schedules that are available on the system.
Routing Svc Off
Manual
Auto
Off prevents the service from being activated.
Manual allows you to turn the service on and off at any time from a control
telephone. This setting overrides any automatically-running schedules.
Auto allows you to program a stop and start time for a service under the
Common Settings heading. These times are then automatically executed when
the service is active.
Default: Off
Overflow <check box> If all the lines used by a route are busy when a call is made, you can program
Routing service to overflow to the route used for normal mode. If the call is
routed to use the normal mode, the telephone sounds a warning tone and
displays the message
Expensive route. The caller then can release the
call to avoid the toll charges or can continue.
Tips: A schedule must be active for overflow routing to be in effect. Overflow
routing is not available in normal mode.
You must create an overflow route to be used with each routing code. In this
way, every route used with a scheduled mode that has overflow service must
have an alternate route in normal service.
Default: Cleared
Ringing Svc Off
Manual
Auto
Off prevents the service from being activated.
Manual allows you to turn the service on and off at any time from a control
telephone. This setting overrides any automatically-running schedules.
Auto allows you to program a stop and start time for a service under the
Common Settings heading. These times are then executed automatically when
the service is active.
Default: Off
For details about setting up ring groups, refer to “Creating ring groups” on
page 95.
Trunk Answer <check box> Trunk answer enables you to answer, from any telephone, an external call that
is ringing at another telephone in your office, if the Ringing Service is active on
that line at the time of the call. If the service is not active, you cannot answer the
call.
Trunk answer is useful if the other telephones are not assigned the same lines
as the telephone you are using to answer the call.
Note: You can change the Trunk Answer setting only if Ringing service is set to
Manual or Auto.
Default: Selected
Extra Dial Set None
DN <XX>
DN <control set>
The Extra dial set attribute allows you to assign an additional telephone to
receive calls for each schedule.
Note: The extra dial set is activated during a schedule by entering the Ringing
service feature code from the assigned direct dial telephone. This does not
activate the Ringing service, unless the direct dial telephone is also a control
set.
Restriction Svc Off
Manual
Auto
Off prevents the service from being activated.
Manual allows you to turn the service on and off at any time from a control
telephone. This setting overrides any automatically-running schedules.
Auto allows you to program a stop and start time for a service under the
Common Settings heading. These times are then executed automatically when
the service is active.
Default: Off
Table 5 Service settings (Sheet 2 of 2)
Attribute Value Description