Filter
Top Products
4-12
Basic Settings for Operating the Motor
4
4.5 Setting the Status to Servo ON
The driver can be put into Servo On status through the following operation.
(1) Click the “I/O Config (I)” button in the “MainMenu” and then the “I/O config (L)” button.
(2) Enable Servo ON. Click the checkmark of “1” under DI and then click the Set (S) button.
Caution
Make sure to click the “Set” button after finishing the setting (the status will become
Servo ON). Verify that the “S-RDY” LED on the front panel is turned on.
!
!!
!
Set Servo ON (DI-1) to “no
check.” (Negative setting)
Set button
Click the I/O Config
(L) button.
Click the I/O Config (I)
button.