Filter
Top Products
3. Printing
252 Printing Guide — Printing from Windows
4. If you want to add a margin on the outside edge, enter a
width in the “Outer Margin” field.
• You can change the unit of the margin at the “Units” drop down box.
• The center margin can be set from 0.000 inch to 1.00 inches in units of 0.01
inch when the unit is inch, and from 0.000 mm to 25.40 mm in units of 0.10
mm when the unit is mm.
5. If you want to double staple the center, check the “Staple
Down the Center” box.
NOTE: “Staple Down the Center” is available only when the Saddle-stitch Finisher is installed
and configured on the Configuration tab.
6. If you want to create a booklet that can be read from right to
left, check the “Number Pages from Right to Left” box.
7. If you want to print or insert a front cover, check the “Use
Front Cover” box and then select, at the “Source” drop down
box, the drawer where the front cover is loaded. Also, at the
“Print Style” drop down box, select whether you are insert-
ing a blank cover or printed front cover.
Do not print on page — Select this to insert a blank front cover.
Print on both sides of page — Select this to print the first two pages and last
two page of document on both sides of a cover.
NOTES: • When “Automatic” is selected in the “Source” drop down box, the paper is automati-
cally selected according to the printed document size.
• The last two page will not be printed or printed only one page if there are no
remained pages or only a last page for the cover.
8. Set other print options you require and click [OK].
9. Click [OK] or [Print] to send a print job.
• The print job is printed as a booklet.
NOTE: If a Saddle-stitch Finisher is not installed, the output will not be folded. But you can cre-
ate a booklet by folding along the center by yourself.
— Printing Several Reduced Pages per Sheet
The N-up feature allows you to condense and print several pages of a document on one
sheet of paper. This feature is very useful for browsing a large number of pages for
appearance or page order.