Filter
Top Products
3. Printing
Printing Guide — Printing from Macintosh 293
Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1) Destination
This selects the destination tray.
- Inner Tray
— Select this when no finisher is installed.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
NOTE: “Tray 1” and “Tray 2” are only available when the Hanging Finisher, Multi-staple Fin-
isher, or Saddle-stitch Finisher are installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off
— Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left
side for the portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for
the portrait document, or on the right for the landscape document.
1
2
3