Filter
Top Products
6. ON LINE MODE EO18-33027
6.1 THRESHOLD SETTING
6- 8
6.1 THRESHOLD SETTING
When a label is printed, the printer detects the gap between the labels using the transmissive sensor, and
corrects the print position automatically to obtain a constant print position. However, when a preprinted label is
used, some inks may prevent proper positioning correction. In this case, determine the transmissive sensor
threshold manually by key operation and store the value in the non-volatile memory (EEPROM).
A constant print position can also be obtained when printing on a preprinted label since the print position is
always corrected using the threshold stored in the non-volatile memory (EEPROM) by selecting “3: Transmissive
Sensor (when using the preprinted label)” for the sensor type of the Issue Command.
When a label is printed by detecting the black mark on the back of the label, the reflective rate variation of a place
other than the black mark may prevent the proper positioning correction. In this case, determine the reflective
sensor threshold manually by key operation and store the value in the non-volatile memory (EEPROM).
A constant print position can also be obtained when printing on a tag since the print position is always corrected
using the threshold stored in the non-volatile memory (EEPROM) by selecting “4: Reflective Sensor (when using
a manual threshold value)” for the sensor type of the Issue Command.
Threshold
Setting Operation Example （English）
[Online mode]
1. Normal condition
↓ Press [PAUSE] Key
[Online mode]
2. Pause condition
↓Hold down [PAUSE] key for 3
seconds
[Threshold setting]
3. Paper sensor
selection
Move cursor by
pressing [UP] Key and
[DOWN] Key
↓ Press [ENTER] Key
[Threshold setting]
4. Wating paper
set
Scroll display by
pressing [UP] Key and
[DOWN] Key
↓ Press [PAUSE] Key
[Threshold setting]
5. Calibration
Continue paper
feeding by keep
pressing [PAUSE] Key
↓ Depress [PAUSE] Key Stop paper feeding by
depressing [PAUSE]
Key
↓ ↓
[Threshold setting]
6a. Judgement: OK
↓
↓
↓
↓
↓ ↓
Move to “3. Paper
sensor selection” by
pressing [FEED] Key
Move to “2. Pause
condition” by pressing