Filter
Top Products
5. SYSTEM MODE EO18-33027
5.11 RFID Module Setting
5-84
5.11.5.2 Multi word write / MULT WRITE
Gen2-compatible Hibiki tag (HITACHI) has a function which reduces the time to write data on the RFID
chips. This is called “Multi-word writes”. Use of this function enables a speed-up of the data write
operation. However, this function is unique to the Hibiki tag, and not usable with the other Gen2-
compatible chips.
Disable / OFF
Enable / ON
5.11.5.3 Carrier sense / CARRIER SENSE
The printer enters the carrier sense mode, and performs a carrier sense. In 5 seconds, environmental radio
wave of each channel is picked up for about 30 times (Enabled only when the B-SX704-RFID-U2 is used.)
LCD Display example
English
The left-most number indicates a channel number, and a percentage means the availability of the channel
which is determined by performing approx. 30 carrier senses. Thus, “100%” means that this channel is
not used by any other devices.
Strength MAX : Method to detect other carrier. There is strong radio origin if value is larger.
“MAX 0011” means the value of the maximum radio wave picked up.
The display can be scrolled up or down, from Channel 1 (1CH) to channel 9 (9CH)
Pressing the [ENTER] key causes the printer to perform a carrier sense again. To quit a carrier sense,
press the [CANCEL] key.
When the RFID module type is set to “NONE” or a communication cannot be established, a message,
“NON RFID MODULE”, is displayed.
When the RFID module type is set to other than U2, a message, “NOT AVAILABLE” is displayed.
When the RFID module type is set to U2 but effective data cannot be obtained, a message, “NO
RESPONSE” is displayed.
When the B-SX704-RFID-U2-US-R is used and if a RFID module’s destination code is not specified (user-
inaccessible setting), an “RFID CONFIG ERR” error message is displayed.