Filter
Top Products
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.2 ROTARY CUTTER (B-EX204-R-QM-R)
4-14
4.2.4 Wiring of the Harness Ass’y
1. Pass the Harness Ass’y through the Cable Protector.
2. Fasten the Harness Ass’y with the Cable Clamp.
3. Connect the Harness Ass’y to J11 on the Main PC board.
4. Close the Print Head Block and Ribbon Shaft Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of
the print head block or damage to the print head.
5. Re-install the Side Panel (L) and close the Top Cover
6. Refer to the Service Manual for the parameter settings and check the cutter operation.
Main PC Board
J11
Harness Ass’y
Cable Clamp
Harness Ass’y
Cable Protector
Harness Ass’y
Cable Clamp