Filter
Top Products
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.10 UHF RFID KIT (B-EX700-RFID-U2-US/EU/CN-R)
4-57
6. Secure the RFID module to the Module Attachment Plates with the three PT-3x6 screws.
7. Connect the RFID Module to J1 on the Main PC Board with the Interface Cable.
8. Re-install the Front Panel and Side Cover (L) in the reverse order of removal. Be careful not to catch
any cables in the Side Cover (L).
For the B-EX700-RFID-U2-US-R model, attach the FCC ID sticker
(USA) or NCC label (Taiwan, in the future) to the back of the printer,
as the picture shows.
For the B-EX700-RFID-U2-CN-R model, attach the SRRC label
to the printer back.
9. Installation of the RFID kit in the printer is now completed. Then, refer to Section 5.11 RFID Module
Setting in the Maintenance Manual to configure the RFID module settings.
J1 Connector
RFID Module
Interface Cable
Main PC Board
PT-3x6
PT-3x6
RFID Module
FCC ID Sticker/NCC Label (In the
future)/SRRC Label