Filter
Top Products
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.3 PEEL-OFF MODULE (B-EX904-H-QM-R)
4-22
13. Connect the Rewinder Harness to J11 on the Main PC board.
14. Connect the Rewind Full Sensor Harness to the 3-pin connector of the Rewinder Harness.
15. When the printer is used in the strip mode, where the printed label is peeled one by one, go to Section
4.3.3 Installing the Strip Sensors.
When the printer is used in the Rewinder mode
, where the printed media is taken up into a roll, go to
Section 4.3.4 Attaching the Rewinder Guide Plate.
4.3.3 Installing the Strip Sensors
1. Turn the head lever counterclockwise to FREE position.
2. Open the ribbon shaft holder plate.
3. Raise the print head block until it stops.
Head Lever
Ribbon Shaft
Holder Plate
Head Lever
Print Head Block
Main PC Board
Rewinder Harness
J11