Filter
Top Products
5. SYSTEM MODE EO18-33027
5.11 RFID Module Setting
5-74
5.11.1 Test / TEST
The following item related test is displayed.
ID Read / ID READ
5.11.1.1 ID Read / ID READ
It changes to reading test mode and the printer read RFID tag. The printer perform reading test by
pressing [ENTER] key. The reading data is displayed on LCD once RFID tag is read.
The error message is displayed on LCD if tag is not read.
Error content English
No module or not available for communication /
NO RFID MODULE
MODULE TYPE ERROR
No country setting / RFID CONFIG ERR COUNTRY CONFIG ERROR
Read tag is different from setting tag / RFID
READ ERROR
READ ERROR
Confirm Setting or
set other Tag.
Not available / NOT AVAILABLE NOT AVAILABLE
No response / NO RESPONSE NO REPONSE
Time out / TIME OUT READ TIMEOUT
set a RF-Tag on Ant.
Other error / UNKNOWN ERROR UNKNOWN ERROR
The only tag which is selected by RFID tag type setting can be read. If tag type is different from RFID tag
type setting, RDID tag reading error is detected. Therefore select RFID tag type before this reading test.
The display is 16 columns and 2 lines.
Display example
English
1st line data X/Y, X: Tag number for result, Y: Total tag number
Most of the case, only 1 tag is read.
If UHF module is used, “Performance/AGC” id displayed on the 2
nd
line by decimal.