Filter
Top Products
5. SYSTEM MODE EO18-33027
5.5 PRINTER PARAMETER FINE ADJUSTMENT
5-42
[Strip position fine adjustment]
0.0
+3.0mm
-3.0mm
4mm
3mm
▼
2mm
Printing in strip issue mode is stopped at the position where
the distance from the middle point of the gap between labels
to the end of the strip shaft is 4 mm, since the gap between
labels is assumed to be 2 mm.
When the print stop position is not proper due to a greater
gap, the print stop position should be adjusted using the
strip position fine adjust function.