Filter
Top Products
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.3 PEEL-OFF MODULE (B-EX904-H-QM-R)
4-19
6. Re-attach the Rewinder Motor Cover with the two screws, and pass the Rewind Full Sensor Harness to
the other side of the Main Frame through the hole.
7. From the MAIN PC board side, unfold the tabs of the Blind Plate (See Step 4), then pull and remove the
Blind Plate.
8. Tilt the Rewinder Ass’y forward to avoid the Supply Holder, and put it against the main frame, as shown
below.
Tab
Blind Plate
Supply Holder
Rewinder Ass’y
Supply Holder
Main Frame
Main Frame
Rewinder Motor Cover
Rewind Full Sensor
Harness
Hole