Filter
Top Products
5. SYSTEM MODE EO18-33027
5.5 PRINTER PARAMETER FINE ADJUSTMENT
5-40
(1) Idling
(2) Completes printing the first label (A).
(3) Feeds the label to the cut position, then cuts
the gap at the front of label (A).
(4) Back feeds to the home position.
(5) Completes printing the second label (B).
(6) Feeds the label to the cut position, then cuts
the gap at the front of label (B).
(7) Back feeds to the home position.
(8) To eject label (B), feeds the third label (C).
(9) Feeds the label to the cut position, then cuts
the gap at the front of label (C).
(10) Back feeds to the home position.
[Method 2] Adjust the cut position fine adjustment value.
When this procedure is used, one or more printed labels are left between the head and
the cutter. Therefore, these labels should be removed by an issue or a label feed.
(a) Cut position fine adjustment value calculation
The cut position fine adjustment value can be calculated using the following method.
If a back feed to the proper home position cannot be performed using this value, the
cut position should be adjusted with any value.
Ex) Label pitch: 30.0 mm
Operation example
Issue count: 2, Cut interval = 1
Cut position Head position
▼ ▼
A
B
A
B
A
B
C
C
A
B C
A
B C
A
B C
A
B
C
B
B
B
A
A
A
C
C
C
Label pitch
(Label pitch)
32.8 mm
* Any decimal remainders are
dropped.
× (Label pitch)
Cut position fine
adjustment value
=
=
(Number of labels left
between head and cutter)
×
32.8 mm
30.0 mm
× (30.0 mm)
Cut position fine
Adjustment value
=
= 1 × 30.0 mm
= +30.0 mm