Filter
Top Products
5. SYSTEM MODE EO18-33027
5.5 PRINTER PARAMETER FINE ADJUSTMENT
5-43
5.5.3 Back feed / BACK ADJ
Max. Min. Step Display Sign Integer
digit
Decimal
point
digit
0 fullfil Unit
9.9 -9.9 0.1 Decimal Exist 1 1 Non mm
+0.0mm
Print start position
(Home position after a back feed)
+3.0mm
Print start position
(Home position after a back feed)
-3.0mm
Print start position
(Home position after a back feed)
(*) There may be cases where a label is not returned to the home position depending on the print
conditions, even if a back feed, of which the length is the same as the forward feed, is performed.
In issues where any paper sensor is used, if the label pitch length is almost the same as the
distance between the thermal print head and the paper sensors (75.5 mm), a label/tag may not
be returned to the home position when operations with a back feed (such as cut issues, strip
issues, automatic forward feed standby) are performed. It may result in an error. In such cases,
to prevent an error from occurring, the back feed length should be increased by performing the
back feed fine adjustment in the + direction.