Filter
Top Products
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.1 DISC CUTTER (B-EX204-QM-R)
4- 8
4.1.3 Wiring of the Harness Ass’y
1. Pass the Harness Ass’y through the Cable Protector.
2. Fasten the Harness Ass’y with the Cable Clamp.
3. Connect the Harness Ass’y to J11 on the Main PC board.
4. Re-install the Side Panel (L) and close the Top Cover.
5. Refer to the Service Manual for the parameter settings and check the cutter operation.
Cable Protector
Harness Ass’y
Main PC Board
J11
Harness Ass’y
Cable Clamp