Filter
Top Products
5. SYSTEM MODE EO18-33027
5.3 SELF-DIAGNOSTIC TEST
5-8
<< PARAMETER SETTINGS >>
Item Content Print value
OFF Disable
STD Feed detected gap/mark
to stop position.
ECO Feed gap/mark between
head and sensor to stop
position.
MEDIA LOAD Media loading
ECO+BFeed Perform back feed after
completion of ECO.
ON Performed
(A fine adjustment value
for the stop position is
also printed.)
FORWARD WAIT Forward feed standby after
an issue
OFF Not performed
MODE1 Stops after 13.7-mm
forward feed.
FW/BK ACT. Forward feed standby action
MODE2 Stops after 6-mm back
feed and 3-mm forward
feed. (Only when the cut
mode, thermal transfer,
and feed gap sensor are
selected.) In other cases,
the printer stops after
13.7-mm forward feed.
ON
Head-up operation is
performed, or the
rewinder is used.
HU CUT/RWD. Head-up operation in cut
issue mode, or use of the
rewinder
OFF Head-up operation is not
performed, or the
rewinder is not used.
ON(TAG) Used when the head lever
position is “TAG”
ON(LBL) Used when the head lever
position is “LABEL”.
RBN SAVE Ribbon saving system
setting
OFF Not used
ON Pre-peel-off operation is
performed.
Pre-peel-off process setting
OFF Pre-peel-off operation is
not performed.
STD 3ips
Back feed speed setting
LOW 2ips
OFF Auto calibration is not
preformed.
ON TRANS. Auto calibrating is
performed by
transmissive sensor.
ON REFLECT Auto calibrating is
performed by reflective
sensor.
ON ALL Auto calibrating is
performed by both
sensor.
AUTO CALIB Auto calibration setting
ON
TRANS.+Bfeed
Perform back feed after
movement of ON
TRANS.