Filter
Top Products
ColorQube™ 9201/9202/9203 General Setup
System Administrator Guide 3-15
2. Enter the Administrator’s User Name [admin], touch [Next], enter Password [1111], touch [Enter].
3. Press the <Machine Status> button.
4. Touch the [Tools] tab.
5. Touch [Network Settings].
6. Touch [Online/Offline].
7. To stop the device receiving or sending jobs over the network touch the [Offline] button. Any installed
optional features using the network (for example Workflow Scanning) will not be available until the
device is set to Online.
Note
To enable the device to receive or send jobs over the network touch the [Online] button.
8. Touch [Close].
9. Press the <Log In/Out> button, then touch [Logout] to exit the Tools pathway.
Auxiliary (Foreign Device) Interface Kit
A third party access and accounting device, such as a coin operated device or a card reader can be attached
to the device. To enable this option, the Foreign Device Interface Kit must be installed. After the kit is
installed the administrator must enable Auxiliary Access as the Accounting Mode from the Tools menu of the
device, as follows:
1. Press the <Log In/Out> button.
2. Enter the Administrator’s User Name [admin], touch [Next], enter Password [1111], touch [Enter].
3. Press the <Machine Status> button.
4. Touch the [Tools] tab.
5. Touch [Accounting Settings].
6. Touch [Accounting Mode].
7. Select [Auxiliary Access] and select available buttons to configure your device.
8. Once selected, touch [Save].
9. Press the <Log In/Out> button, then touch [Logout] to exit the Tools pathway.
For further instructions on Auxiliary (Foreign Device) Interface Setup options refer to the Interactive User
Guide delivered with your device.
SNMP (Simple Network Management Protocol)
It is possible to remotely define and modify GET, SET, and TRAP SNMP (Simple Network Management
Protocol) community names for the device. You can also configure SNMP trap destinations for TCP/IP and
NetWare (IPX) that will receive traps from any device on the network.
SNMP Community Name properties that can be configured are:
• GET Returns the password for SNMP GET requests to the device. Applications obtaining information
from the device via SNMP, such as Xerox PrinterMap or CentreWare, use this password.
• SET Returns the password for SNMP SET requests to the device. Applications that set information on the
device via SNMP, such as Xerox PrinterMap or CentreWare, use this password.
• TRAP Returns the password for SNMP TRAPS from the device. This is the default password for SNMP
TRAPS sent from the device via SNMP.