Filter
Top Products
Network Installation ColorQube™ 9201/9202/9203
5-28 System Administrator Guide
AS400 Raw TCP/IP Printing to Port 9100
(CRTDEVPRT)
This is the procedure to set up printing to a device from an AS/400 using the SNMP drivers.
This procedure is intended for users familiar with the AS/400 system, especially those experienced with
printing in an AS/400 environment.
The AS/400 must run V4R5 of OS/400 so that the SNMP drivers are present (or V4R3/V4R4 with the most
current PTFs installed).
The device must have port 9100 enabled.
Procedures to Enable Port 9100
1. At your Workstation, open the web browser and enter the IP address of the device in the Address bar,
and press [Enter].
2. Click the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4. Click on the [Login] button.
5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
7. Select [Raw TCP/IP Printing] in the directory tree.
8. Ensure the [Enabled] box is checked to enable Raw TCP/IP Printing.
9. Leave the [TCP Port Number] set to 9100 for Port 1.
10. Leave the [Bidirectional] and [Maximum Connections] settings at their default values.
11. Set the [End of Job Timeout] to the number of seconds to wait before processing a job without an End
Of Job indicator.
12. Leave the [PDL Switching] Enabled box at its default value.
13. Click on the [Apply] button to accept the changes, or [Undo] to return the settings to their previous
values, or [Default All] to enter printer defaults for all settings (recommended).
14. Click on the [OK] button, when you see the window that says “Properties have been successfully
modified”.
Note
The settings are not applied until you restart the device.
Create a Device Description
Create a device description from your AS400 terminal's command line.
1. Select the F-4 key to prompt the CRTDEVPRT command. Enter the following parameters:
Device Description: Xeroxprinter
Device Class: *lan
Device Type: 3812
Device Model: 1
2. Press [Enter] to continue, and enter the following parameters: