ARM r1p3 Computer Hardware User Manual


 
Debug
ARM DDI 0363E Copyright © 2009 ARM Limited. All rights reserved. 11-41
ID013010 Non-Confidential, Unrestricted Access
11.7 Debug exception
The processor takes a debug exception when a software debug event occurs while in Monitor
debug-mode. Prefetch Abort and Data Abort Vector catch debug events are ignored. The debug
software must carefully program certain debug events to prevent the processor from entering an
unrecoverable state. If the processor takes a debug exception because of a breakpoint, BKPT, or
vector catch debug event, the processor performs the following actions:
sets the DSCR[5:2] method-of-entry bits to indicate that a breakpoint occurred
sets the CP15 IFSR and IFAR registers as described in Effect of debug exceptions on CP15
registers and WFAR on page 11-42
performs the same sequence of actions as in a Prefetch Abort exception by:
updating the SPSR_abt with the saved CPSR
changing the CPSR to abort mode and the state indicated by the TE bit with normal
interrupts and imprecise aborts disabled
setting R14_abt as for a regular Prefetch Abort exception, that is, this register holds
the address of the cancelled instruction plus
0x04
setting the PC to the appropriate Prefetch Abort vector.
Note
The Prefetch Abort handler is responsible for checking the IFSR to determine if a debug
exception or other kind of Prefetch Abort exception caused the exception entry. If the cause is
a debug exception, the Prefetch Abort handler must branch to the debug monitor. The R14_abt
register holds the address of the instruction to restart.
If the processor takes a debug exception because of a watchpoint debug event, the processor
performs the following actions:
sets the DSCR[5:2] method-of-entry bits to indicate that a precise watchpoint occurred
sets the CP15 DFSR, DFAR, and WFAR registers as described in Effect of debug
exceptions on CP15 registers and WFAR on page 11-42
performs the same sequence of actions as in a Data Abort exception by:
updating the SPSR_abt with the saved CPSR
changing the CPSR to the state indicated by the TE bit with normal interrupts and
imprecise aborts disabled
setting R14_abt as a regular Data Abort exception, that is, this register gets the
address of the cancelled instruction plus
0x08
setting the PC to the appropriate Data Abort vector.
Note
The Data Abort handler must check the DFSR to determine if the exception entry was caused
by a Debug exception or other kind of Data Abort exception. If the cause is a Debug exception,
the Data Abort handler must branch to the debug monitor. The R14_abt register holds the
address of the instruction to restart.