Filter
Top Products
COPYRIGHT
©
1998 CANON INC. CANON NP7161/NP7160 REV.0 AUG. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
8–9
CHAPTER 8 INSTALLATION
Step Work Checks/remarks
When drum unit installation mode has
been executed, press the Reset key to
end service mode.
7
While the toner is being stirred,
perform the following:
1)Set the cassette size to suit the
needs of the user, and put copy
paper inside the cassette.
2)Mount the copy tray to the
copier.
6 To switch the cassette between AB and Inch, see
the instructions under “Changing the Cassette
Size (AB/Inch). (See p. 5-25.)
Copy tray
Place the Test Sheet on the copyboard
glass, and make copies using each
cassette. Then, check the copy images.
8
• Check to make sure that there is no
abnormal noise.
• Check to make sure that as many copies as
set are made normally.
• Check the copies (images) made at each
default reproduction ratio.
If images are not optimum, perform the
“Image Adjustment Basic Procedure.” (p.
10-3)
• Check to make sure that copying operation
in each copying mode is normal.
• Check to make sure that the counter operates
normally.
Fill out the Service Sheet.
If you are installing accessories (e.g.,
sorter), install them according to their
respective Installation Procedures.
Clean up the area around the machine.10
11
12
Make user mode settings and service
mode settings 5 to suit the user's
needs.
9