Filter
Top Products
3-9
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 3 Node Setup
Creating Protection Groups
Step 5 Click OK and click Apply.
3.5 Creating Protection Groups
The ONS 15454 provides several card protection methods. When you set up protection for ONS 15454
cards, you must choose between maximum protection and maximum slot availability. The highest
protection reduces the number of available card slots; the highest slot availability reduces the protection.
Table 3-3 shows the protection types that can be set up for ONS 15454 cards.
Procedure: Create Protection Groups
Step 1 From the CTC node view, click the Provisioning > Protection tabs.
Step 2 Under Protection Groups, click Create.
Step 3 In the Create Protection Group dialog box, enter the following:
• Name—Type a name for the protection group. The name can have up to 32 alpha-numeric characters.
• Type—Choose the protection type: 1:1, 1:N, or 1+1. The protection selected determines the cards
that are available to serve as protect and working cards. For example, if you choose 1:N protection,
only DS-1N and DS-3N cards are displayed.
• Protect Card or Port—Choose the protect card (if using 1:1 or 1:N) or protect port (if using 1+1)
from the list.
Table 3-3 Protection Types
Type Cards Description
1:1 DS-1
DS-3
EC-1-12
DS3XM-6
Pairs one working card with one protect card. Install the protect card in
an odd-numbered slot and the working card in an even-numbered slot
next to the protect slot towards the center, for example: protect in Slot
1, working in Slot 2; protect in Slot 3, working in Slot 4; protect in Slot
15, working in Slot 14.
1:N DS-1
DS-3
Assigns one protect card for several working cards. The maximum is
1:5. Protect cards (DS1N-14, DS3N-12) must be installed in Slots 3 or
15 and the cards they protect must be on the same side of the shelf.
Protect cards must match the cards they protect. For example, a
DS1N-14 can only protect DS1-14 or DS1N-14 cards. If a failure clears,
traffic reverts to the working card after the reversion time has elapsed.
1+1 Any optical Pairs a working optical port with a protect optical port. Protect ports
must match the working ports. For example, Port 1 of an OC-3 card can
only be protected by Port 1 of another OC-3 card. Cards do not need to
be in adjoining slots.
Unprotected Any Unprotected cards can cause signal loss if a card fails or incurs a signal
error. However, because no card slots are reserved for protection,
unprotected schemes maximize the service available for use on the ONS
15454. Unprotected is the default protection type.