Filter
Top Products
11-4
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter 11 SNMP
SNMP Support
Figure 11-4 Setting up SNMP
Step 4 Type the IP address of your NMS in the IP Address field.
Step 5 Type the SNMP community name in the Community Name field.
For a description of SNMP community names, see the “SNMP Community Names” section on
page 11-8.
Note The community name is a form of authentication and access control. The community name
assigned to the ONS 15454 is case-sensitive and must match the community name of the
NMS.
Note The default UDP port for SNMP is 162.
Step 6 Set the Trap Version field for either SNMPv1 or SNMPv2.
Refer to your NMS documentation to determine whether to use SNMP v1 or v2.
Step 7 Set your maximum traps per second in the Max Traps per Second field.
Note The Max Traps per Second is the maximum number of traps per second that will be sent to
the SNMP manager. If the field is set to 0, there is no maximum and all traps are sent.
Step 8 Click OK.
SNMP settings are now configured. To view SNMP information for each node, highlight the node IP
address in the Trap Destinations area of the Trap Destinations screen (Figure 11-5).